How to Measure, Assemble and Fit our Blinds

Measuring for your new window coverings couldn’t be simpler.

All you have to do is follow our easy, step-by-step guide below.

Tools needed:

Steps to follow:

1. Using a good metal tape measure, measure the visible glass up to the rubber gasket across the width of the window,  Measure the top, middle and bottom and take note of the smallest width in millimetres, Frame Depth.
2. Now measure the drop of the visible glass up to the rubber gasket, Measure in 3 places again and note the smallest drop in millimetres.
3. The frame depth is measured from the glass, straight out towards the edge of your window frame. The best way to do this is use a straight edge, like a credit card overhanging the frame onto the glass, and measure up from the glass to the card. This measurement is your frame depth. You now need to measure to frame depth to the glass, using a credit card, place it on the frame over the corner of the frame and measure to the glass and take a note of the measurement in millimetres. The following is the bracket size required for the depth that you have measured.
   • 18 mm to 19 mm – 18 mm bracket
   • 20 mm to 21 mm – 20 mm bracket
   • 22 mm to 23 mm – 22 mm bracket
   • 24 mm to 25 mm – 24 mm bracket
   • 26 mm to 27 mm – 26 mm bracket
   • 28 mm to 29 mm – 28 mm bracket
   • 30 mm to 31 mm – 30 mm bracket

• Take a note of which side you prefer your operating wand, we would suggest having wands on the inner of the opening of your doors, but the choice is yours.
• You can now enter these measurements into our measurement calculator and check your measurements again before submitting.

PLEASE MAKE SURE YOU CHECK ALL MEASUREMENTS AT LEAST TWICE AS WE ALL CAN MAKE A MISTAKE.